pa system philippines

Thank you for visiting this public address system blog. :)

Let me talk a little bit more about my experience handing a Philippine PA system. Again, to be more specific, this was a portable wireless public address system, which I was able to make use of in the Philippines.

In this article I will focus on my experience getting this Philippine PA system up and running, so that basically means I'll be discussing the setup. Let me begin.

When I first saw this Philippine PA system, it was in a box. Not that the device was brand-new or anything, because it appeared that this was more of a demonstration unit. But the box itself looked alright. So I opened the box, remove the pieces of styrofoam, and took the various pieces out of the plastic bags in which they were wrapped.

Of course, there was the main component of the Philippine PA system, which was basically the main unit where the front of the device was taken up in its entirety by the speaker area, and the rear of the device contained the various buttons, switches, dials, indicator lights, and pretty much everything else.

What I did first was take the power cord and plug it into the main unit. I then ran the other end of the power cord over to the outlet. Now, this Philippine PA system is portable which means that it possesses a rechargeable battery, so that it can run even if it isn't connected to a power outlet. Even so, I thought I would start by first using the device with it plugged into an outlet.

When I plugged in the device, the unit indicated that its battery was charging. That's because the unit switch was set to off. Now, the device comes with three microphones in all. A wireless microphone which looks more like a traditional microphone. A lapel mic, or a microphone which you basically clip around your collar area. And a headset microphone, which is worn basically like the headsets used in call centers. In the case of the lapel mic, and the headset mic, they each have cords which run to a small boxlike device which you can connect to your belt. This is the device which sends a wireless signal which connects the microphone to the base unit.

Now, the traditional looking mic is powered by what appears to be a small rectangular battery, which looks like regular nine volt batteries. Thankfully, the unit comes with a rechargeable battery for that microphone. Another battery is needed for the boxlike device to which the lapel mic or the headset mic can be attached. This battery also looks like a nine volt battery. Again, the unit comes with a second battery for this boxlike device.

Another great thing is that the main unit has a slot which charges those two smaller batteries. So basically, when the main device is plugged into an outlet, and the switch is turned off, you're charging the battery of the main unit, and you can also charge one of the smaller batteries of a wireless microphone.

So basically the Philippine PA system had its main unit plugged into an outlet. I first decided to try out the more traditional looking wireless microphone. So what I did was I unscrewed the bottom of that mic, I plugged in the small battery, and I screwed the microphone closed. I then turned on the main unit, adjusted the wireless microphone volume, switched on the wireless mic, and started talking. Immediately my voice started to get picked up by the main unit speaker, and it was amplified many times its normal volume.

Again, I wandered around the location moving further away from the main unit, but even if I was already far away, and even if there were walls between me and the main unit, the Philippine PA system did not disappoint.

I then decided to try the other two wireless microphone accessories. So I got the boxlike device which I could clip on my belt, I slid it open so I could plug in the battery, and I closed it again. I then clipped that device to my belt. Once done, I took the lapel mic and plugged it into the boxlike device after which, I clipped the lapel mic to my collar. Again, after I turned on the wireless microphone by clicking a switch on the boxlike device, my voice was amplified many times its normal volume. And as I wandered around again, I didn't receive any problem with my wireless connection to the base unit.

So that's a little bit of a discussion regarding my first impressions of this Philippine PA system. I hope you found my discussion of the device a bit interesting, and maybe a bit helpful.

Again, thank you for visiting this Philippine PA system blog. :)